REMOVAL AND INSTALLATION



Pre-removal operation
  • Door trim assembly removal (Refer to GROUP 52A - Door Trim .)
  • Waterproof film removal (Refer to .)

Post-installation operation
  • Door inside handle play check (Refer to .)
  • Door outside handle play check (Refer to .)
  • Waterproof film installation (Refer to .)
  • Door trim assembly installation (Refer to GROUP 52A - Door Trim .)







Door inside handle removal


1.
Door inside handle



Door outside handle removal steps 


2.
Plug


3.
Front door lock cover (Driver’s side) <Vehicles with dead lock system>


4.
Damper (Driver’s side) <Vehicles with dead lock system>


5.
Door lock key cylinder (Driver’s side)


6.
Door outside handle cover


7.
Door outside handle


8.
Door outside handle gasket


9.
Door outside handle base


10.
Keyless operation switch


11.
Clip



Door latch assembly removal steps 


1.
Door inside handle


12.
Door speaker bracket <Vehicles with audio amplifier>


13.
Screw
<<A>>

14.
Door lock cover
<<A>>

15.
Door latch assembly

>>B<<
16.
Door inside lock cable

>>B<<
17.
Door inside handle cable


18.
Door outside handle rod


19.
Clip



Door check removal steps


·
Front door speaker (Refer to GROUP 54A - Speaker .)

>>A<<
20.
Door check






Door inside handle removal


1.
Door inside handle



Door outside handle removal steps


2.
Plug


3.
Door outside handle cover


4.
Door outside handle


5.
Door outside handle gasket


6.
Door outside handle base


7.
Clip



Door latch assembly removal steps 


1.
Door inside handle


8.
Screw
<<A>>

9.
Door lock cover
<<A>>

10.
Door latch assembly

>>B<<
11.
Door inside lock cable

>>B<<
12.
Door inside handle cable


13.
Door outside handle rod


14.
Clip



Door check removal steps


·
Rear door speaker (Refer to GROUP 54A, Speaker .)

>>A<<
15.
Door check

REMOVAL SERVICE POINT



<<A>> DOOR LOCK COVER/ DOOR LATCH ASSEMBLY REMOVAL



Remove the door lock cover in the following procedures:
1.Release the upper and lower claws of the door lock cover by using a flat-tipped screwdriver.
2.Pull the cover out a little.
3.With the cover pulled out state, slide it toward cabled side and remove it from the door latch assembly.

INSTALLATION SERVICE POINTS



>>A<< DOOR CHECK INSTALLATION



Install the door check with the following identification mark facing upward.
Application
Identification mark
Front door
Left door
55L
Right door
55R
Rear door
Left door
64L
Right door
64R

>>B<< DOOR INSIDE LOCK CABLE/ DOOR INSIDE HANDLE CABLE INSTALLATION



Connect the door inside lock cable and door inside handle cable to the door inside handle according to the identification colour marked on the cables as shown in the illustration.