|
The lighting control sensor, the harness connector, or the ETACS-ECU may be defective.
|
|
- Malfunction of the lighting control sensor
- Malfunction of ETACS-ECU
- Damaged wiring harness and connectors
|
|
Visually check the presence of scratches or air bubbles (diameter of 5 mm or more) on
the windshield to which the lighting control sensor is installed.
|
|
Q.
Is the check result normal?
|
|
Replace the windshield (Refer to GROUP 42A - Windshield Removal and Installation ).
|
|
|
|
Check that the windshield wipers work normally.
|
|
Q.
Is the check result normal?
|
|
Refer to trouble symptom chart .
|
|
|
|
Check if an ETACS-related diagnosis code is set.
|
|
Q.
Is the diagnosis code set?
|
|
Diagnose the ETACS-ECU. Refer to GROUP 54A - ETACS .
|
|
|
|
Check if a lighting control sensor-related diagnosis code is set.
|
|
Q.
Is the diagnosis code set?
|
|
Diagnose the lighting control sensor. (Refer to GROUP 54A - Diagnosis
Code Chart .)
|
|
|
|
Q.
Is the check result normal?
|
|
Repair the damaged connector.
|
|
|
|
(1)Disconnect the connector, and measure the voltage at the wiring harness side.
|
|
(2)Measure the voltage between C-416 ETACS-ECU connector terminal No. 1 and body earth. OK: System voltage
|
|
Q.
Is the check result normal?
|
|
Replace the Lighting control sensor.
|
|
|
|
- Check the input and output lines for open or short circuit.
|
|
Q.
Is the check result normal?
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection
Service Points - How to Cope with Intermittent Malfunction .)
|
|
|
|
Repair the wiring harness.
|
|
|