Code No. P0ADB: Main contactor (+) circuit (low input)
Code No. P0ADF: Main contactor (-) circuit (low input)



HIGH VOLTAGE POWER SUPPLY CONTROL SYSTEM CIRCUIT







OPERATION




DIAGNOSIS CODE SET CONDITIONS



  • When the excitation circuit monitor of the main contactor (+) in the main battery is off while the main contactor (+) in the main battery ON command is underway, the diagnosis code No. P0ADB will be set.

  • When the excitation circuit monitor of the main contactor (-) in the main battery is off while the main contactor (-) in the main battery ON command is underway, the diagnosis code No. P0ADF will be set.

PROBABLE CAUSES



  • Damaged wiring harness or connector(s)
  • Malfunction of the main battery
  • Malfunction of the EV-ECU

DIAGNOSIS PROCEDURE


STEP 1. Connector check: C-22 main battery connector, C-111 EV-ECU connector


Q. Is the check result normal?

Go to Step 2.
Repair the damaged connector.

STEP 2. Check the wiring harness between C-111 EV-ECU connector terminal No. 106, 107 and C-22 main battery connector terminal No. 3, 6.


Check the signal lines for open circuit and short to earth.

Q. Is the check result normal?

Go to Step 3.
Repair the wiring harness.

STEP 3. Diagnosis code recheck


Check again if the diagnosis code is set to the EV-ECU.
(1)Erase the stored diagnosis code.
(2)Set the electric motor switch from the "LOCK" (OFF) position to the "ON", and then to the "START" position temporarily.
(3)Check if the diagnosis code is set.

Q. Is the diagnosis code set?

Replace the EV-ECU. (Refer to .) Then go to Step 4.
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction .)

STEP 4. Diagnosis code recheck


Check again if the diagnosis code is set to the EV-ECU.
(1)Erase the stored diagnosis code.
(2)Set the electric motor switch from the "LOCK" (OFF) position to the "ON", and then to the "START" position temporarily.
(3)Check if the diagnosis code is set.

Q. Is the diagnosis code set?

Replace the main battery. (Refer to .) Then go to Step 5.
The diagnosis is complete.

STEP 5. Diagnosis code recheck


Check again if the diagnosis code is set to the EV-ECU.
(1)Erase the stored diagnosis code.
(2)Set the electric motor switch from the "LOCK" (OFF) position to the "ON", and then to the "START" position temporarily.
(3)Check if the diagnosis code is set.

Q. Is the diagnosis code set?

Return to Step 1.
The diagnosis is complete.