REMOVAL AND INSTALLATION


caution
  • For vehicles with ABS, be careful not to strike the pole piece at the tip of the front wheel speed sensor with tools during servicing work.
  • *: Indicates parts which should be temporarily tightened, and then fully tightened with the vehicle on the earth in an unladen condition.
Pre-removal Operation
  • Brake Fluid Draining

 Post-installation Operation
  • Brake Fluid Filling and Air Bleeding (Refer to GROUP 35A, On-vehicle Service .)

  • Parking Brake Lever Stroke Adjustment (Refer to GROUP 36, On-vehicle Service .)




Removal steps


1.
 Brake drum


2.
 Shoe and lining assembly (Refer to GROUP 35A, Rear Drum Brake , .)


3.
 Parking brake cable attaching bolt


4.
 Parking brake cable connection


5.
 Rear wheel speed sensor <Vehicles with ABS>


6.
 O-ring <Vehicles with ABS>


7.
 Brake hose and brake tube connection


8.
 Bolt <Vehicles without ABS>


9.
 Breather hose connection


10.
 Spring support
<<A>>
 >>A<<
 11.
 Propeller shaft connection
<<B>>
12.
 Shock absorber connection


13.
 U bolt seat


14.
 U bolt


15.
 Bump stopper
<<C>>
16.
 Axle assembly

REMOVAL SERVICE POINTS

<<A>> PROPELLER SHAFT REMOVAL
caution Suspend the propeller shaft from the body with wire, etc. to prevent it from falling.

Place mating marks on the companion flange and flange yoke. Disconnect the propeller shaft from the companion flange.

<<B>> SHOCK ABSORBER DISCONNECTION

Support the axle housing with a jack before removing the shock absorber lower mounting nut.

<<C>> AXLE ASSEMBLY REMOVAL
warning Secure the axle assembly to the jack or equivalent. The axle assembly is heavy and unstable and may fall causing damage to the assembly, surrounding equipment, or injuring the installer.
Take out the axle assembly from the rear of the vehicle.

INSTALLATION SERVICE POINT

>>A<< PROPELLER SHAFT INSTALLATION

Align the mating marks on the flange yoke and the companion flange to install the propeller shaft.