REMOVAL AND INSTALLATION


caution Do not apply grease or lubricant to the switch and the switch installation section to avoid malfunction of the switch. In addition, do not use gloves which have grease on them.
Pre-removal OperationLower panel assembly removal (Refer to GROUP 52A - Instrument Panel Assembly ).
 Post-installation Operation
  • Parking brake pull rod stroke adjustment (Refer to ).
  • Lower panel assembly installation (Refer to GROUP 52A - Instrument Panel Assembly ).




Removal steps


1.
 Parking brake switch


2.
 Return spring


3.
 Parking brake front cable connection (lever side)


4.
 Clip


5.
 Clip


6.
 Pin


7.
 Pin


8.
 Parking brake front cable connection (parking brake pull rod side)
<<A>>
9.
 Parking brake front cable assembly


10.
 Parking brake pull rod assembly

REMOVAL SERVICE POINT

<<A>> PARKING BRAKE FRONT CABLE AND PARKING BRAKE PULL ROD ASSEMBLY CONNECTION

Pull the parking brake pull rod to the position shown in the figure. Then, fit the pin to the groove and remove the parking brake front cable.