|
|
1.Carry out the following check.
Inspection procedure
|
Check conditions
|
Items to be checked (Normal conditions)
|
1
|
Brake pedal: Depress
|
Ignition switch position: "LOCK" (OFF) or removed
|
The selector lever cannot be moved out of "P" position.
|
2
|
Ignition switch position: "ON"
|
The selector lever can be moved from "P" position to other positions
smoothly.
|
3
|
Transmission range: Other than "P"
|
The ignition switch cannot be turned to the "LOCK" (OFF) position.
|
4
|
Transmission range: "P"
|
The ignition switch can be turned to the "LOCK" (OFF) position smoothly.
|
|
|
2.If the normal conditions are not obtained after performing the above operations, install
the key interlock cable in the following procedures. (Automatic adjustment)
(1)
Disconnect the key interlock cable connection (selector lever side) (Refer to  ).
(2)
|
|
| caution |
Leave the ignition switch in the "LOCK" (OFF) position until
the key interlock cable installation is completed.
|
|
Move the selector lever to the "P" position and turn the ignition switch to the "LOCK"
(OFF) position.
(3)
Install the tip of the key interlock cable to the lock cam of the selector lever assembly,
taking care not to twist the inner cable.
(4)
Install the adjuster case with its lock guide pulled up (unlocked).
(5)
Securely push down the lock guide to lock it.
|
|
| note |
The lock position of the key interlock cable is automatically adjusted by a spring.
|
|
|