|
Connect the M.U.T.-III to the 16-pin diagnosis connector, and read the diagnosis code.
note |
For details on how to use the M.U.T.-III, refer to the "M.U.T.-III operation manual."
|
1.Ensure that the ignition switch is at the "LOCK" (OFF) position. 2.Start up the personal computer. 3.Connect special tool M.U.T.-III USB cable (MB991827) to V.C.I. (MB991824) and the personal computer. 4.Connect M.U.T.-III main harness A (MB991910) to the V.C.I. 5.Connect the M.U.T.-III main harness A to the diagnosis connector of the vehicle. 6.Turn the V.C.I. power switch to the "ON" position.
note |
When the V.C.I. is energized, the V.C.I. indicator lamp will be illuminated in a green colour.
|
7.Start the M.U.T.-III system on the personal computer and turn the ignition switch to the "ON" position. 8.Read the diagnosis code. 9.Disconnecting the M.U.T.-III is the reverse of the connecting sequence, making sure that the ignition switch is at the "LOCK" (OFF) position.
|
|
Connect the M.U.T.-III to the diagnosis connector, and erase the diagnosis code. The procedure is the same as "How to Read Diagnosis Code ."
|