|
Turn the ignition switch to the "LOCK" (OFF) position when connecting and disconnecting the connectors. Turn the ignition switch to "ON" when measuring, unless there are instructions to the contrary.
|
|
Use the special tools such as test harness, harness connector or check harness.
|
|
Inspect by inserting a test probe from the harness side. If the connector is too small to insert a test probe (e.g. control unit connector), do not insert it forcibly. Use special tool extra fine probe (MB992006).
|
|
Use inspection harness (MB991219) of special tool harness set (MB991223).
|
|
Touch the pin directly with the test bar.
|