REMOVAL AND INSTALLATION



Removal steps


1.
 Water hose


2.
 Water hose

>>C<<
 3.
 Coolant temperature sensor


4.
 Water outlet fitting


5.
 Outlet fitting gasket


6.
 Water inlet fitting

>>B<<
 7.
 Thermostat

>>A<<
 8.
 Thermostat housing


9.
 Thermostat housing gasket

>>A<<
 10.
 Water pipe assembly


11.
 Water pipe gasket


12.
 O-ring


13.
 Water pump assembly


14.
 Water pump gasket


15.
 Engine hanger


16.
 Camshaft position sensor


17.
 O-ring


18.
 Camshaft position sensor


19.
 O-ring

INSTALLATION SERVICE POINTS

>>A<< THERMOSTAT HOUSING / WATER PIPE ASSEMBLY INSTALLATION
Assemble the thermostat housing and water pipe, and temporarily tighten them to the cylinder head and water pump. Then tighten them to the specified torque of 24 ± 3 N·m.

>>B<< THERMOSTAT INSTALLATION



Install the thermostat with the jiggle-valve facing almost straight upwards.

>>C<< COOLANT TEMPERATURE SENSOR INSTALLATION
caution Be careful not to give a shock, twist and the like to the resin mold with a tool during installation.

1.Apply an appropriate and minimum amount of sealant to the coolant temperature sensor, taking care not to allow sealant to squeeze out.
Specified sealant:
    Loctite 262, Three bond 1324 or equivalent
2.Tighten the coolant temperature sensor to the cylinder block to the specified torque of 30 ± 9 N·m.