Code No. P0327: Right Bank Detonation Sensor Circuit Low Input










OPERATION



  • The sensor signal is input to the engine-ECU (terminal No. 28) from the right bank detonation sensor (terminal No. 1).
  • The power voltage is earthed to the engine-ECU (terminal No. 29) from the right bank detonation sensor (terminal No. 2).

FUNCTION



  • The detonation sensor detects the vibration of the cylinder block caused by detonation waves, and inputs a signal to the engine-ECU.
  • In response to the signal, the engine-ECU provides controls to retard the ignition timing when the detonation occurs.

TROUBLE JUDGMENT


Check Condition
  • 2 seconds or more have passed since the engine starting sequence was completed.
Judgment Criterion
  • Right bank detonation sensor output voltage has continued to be lower than 0.5 V for 2 seconds.

PROBABLE CAUSES



  • Failed right bank detonation sensor
  • Open/short circuit or harness damage in right bank detonation sensor circuit or loose connector contact
  • Failed engine-ECU

DIAGNOSIS PROCEDURE


STEP 1. Connector check: B-37 right bank detonation sensor connector


Q. Is the check result normal?

Go to Step 2 .
Repair or replace the connector.

STEP 2. Perform resistance measurement at B-37 right bank detonation sensor connector.



  • Disconnect connector, and measure at harness side.
  • Resistance between terminal No. 2 and earth.
OK: Continuity (2 Ω or less)

Q. Is the check result normal?

Go to Step 6 .
Go to Step 3 .

STEP 3. Connector check: B-29 engine-ECU connector


Q. Is the check result normal?

Go to Step 4 .
Repair or replace the connector.

STEP 4. Check harness between B-37 (terminal No. 2) right bank detonation sensor connector and B-29 (terminal No. 29) engine-ECU connector.



  • Check earthing line for open circuit and damage.

Q. Is the check result normal?

Go to Step 5 .
Repair the damaged harness wire.

STEP 5. M.U.T.-III diagnosis code



  • Reconfirmation of diagnosis code.

Q. Is diagnosis code set?

Replace the engine-ECU.
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).

STEP 6. Connector check: B-29 engine-ECU connector


Q. Is the check result normal?

Go to Step 7 .
Repair or replace the connector.

STEP 7. Check harness between B-37 (terminal No. 1) right bank detonation sensor and B-29 (terminal No. 28) engine-ECU connector.



  • Check output line for open/short circuit and damage.

Q. Is the check result normal?

Go to Step 8 .
Repair the damaged harness wire.

STEP 8. M.U.T.-III diagnosis code



  • Reconfirmation of diagnosis code.

Q. Is diagnosis code set?

Go to Step 9 .
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).

STEP 9. M.U.T.-III diagnosis code



  • Reconfirm diagnosis code after replacement of right bank detonation sensor.

Q. Is diagnosis code set?

Replace the engine-ECU.
Check end.