|
|
1.Turn the ignition switch to the "ON" position.
|
|
2.Press the "ON/OFF" switch of the cruise control switch, and check that the cruise control indicator lamp within the combination meter illuminates.
3.Press the "ON/OFF" switch again, and check that the cruise control indicator lamp within the combination meter goes out.
|
|
1.Switch ON the "ON/OFF" switch.
2.Drive at the desired speed within the range of approximately 40 - 160 km/h.
|
|
3.Push the "COAST/SET" switch.
4.Check to be sure that when the "COAST/SET" switch is released the speed is the desired constant speed.
| note |
If the vehicle speed decreases to approximately 15 km/h below the set speed because of climbing a hill for example, it is normal for the cruise control to be cancelled. When the vehicle speed is decelerated to the low speed limit (approximately 40 km/h) or less, the constant speed driving will be cancelled even if the vehicle speed is not decelerated 15 km/h or more from the set speed.
|
|
|
1.Switch ON the "ON/OFF" switch.
2.Set to the desired speed within the range of approximately 40 - 160 km/h.
|
|
3.Push the "ACC/RES" switch.
4.Check to be sure that acceleration continues while the "ACC/RES" switch is pushed, and that the speed at the time it was released becomes the constant driving speed.
| note |
Acceleration can be continued even if the vehicle speed has passed the high speed limit (approximately 160 km/h). But the constant driving speed when the "ACC/RES" switch is released will be recorded as the high speed limit (approximately 160 km/h).
|
|
|
1.Switch ON the "ON/OFF" switch.
2.Set to the desired speed within the range of approximately 40 - 160 km/h.
|
|
3.Push the "COAST/SET" switch.
4.Check to be sure that deceleration continues while the "COAST/SET" switch is pushed, and that the speed at the time it was released becomes the constant driving speed.
| note |
When the vehicle speed reaches the low speed limit (approximately 40 km/h) during deceleration, the cruise control will be cancelled.
|
|
|
1.Switch ON the "ON/OFF" switch.
2.Set to the desired speed within the range of approximately 40 - 160 km/h.
|
|
3.When any of the following operations are performed while at constant speed during cruise control, check if normal driving is resumed and deceleration occurs.
(1)
The "CANCEL" switch is pushed.
(2)
The brake pedal is depressed.
|
|
4.At a vehicle speed of the low speed limit (approximately 40 km/h) or higher, check if when the "ACC/RES" switch is pushed, the vehicle speed returns to the speed before cruise control driving was cancelled, and constant speed driving occurs.
5.When the "ON/OFF" switch is switched to the OFF while driving at constant speed, check if normal driving is resumed and deceleration occurs.
|