DISASSEMBLY AND REASSEMBLY







Disassembly steps


1.
Oil receiver pipe A


2.
Oil receiver pipe B


3.
With head straight screw plug


4.
Slotted spring pin


5.
Reverse restrict pin assembly
<<A>>
>>C<<
6.
Tapered roller bearing outer race


7.
Shim
<<B>>
>>B<<
8.
Tapered roller bearing outer race


9.
Shim

>>A<<
10.
Oil seal

DISASSEMBLY SERVICE POINTS



<<A>> TAPERED ROLLER BEARING OUTER RACE REMOVAL



Using special tool Knuckle oil seal installer (MB991015), remove the tapered roller bearing outer race.

<<B>> TAPERED ROLLER BEARING OUTER RACE REMOVAL



Using special tools, remove the tapered roller bearing outer race.

  • Slide hammer (MB990211)
  • Slide hammer puller (MB992039)

REASSEMBLY SERVICE POINTS



>>A<< OIL SEAL INSTALLATION




1.Using special tools, press-fit the oil seal until the difference in height between the transmission case and oil seal is obtained as shown.

  • Oil seal installer (MB992210)
  • Handle (MB992075)
2.Pack grease to the oil seal lip area.
Specified grease:
Mitsubishi Part No. 0101011 or equivalent

>>B<< TAPERED ROLLER BEARING OUTER RACE INSTALLATION



Using special tool Bearing outer race installer (MB991966), Install the tapered roller bearing outer race.

>>C<< TAPERED ROLLER BEARING OUTER RACE INSTALLATION



1.Set special tools,Install the tapered roller bearing outer race

  • Knuckle oil seal installer (MB991015)
  • Installer bar (MB990938)

2.Press-fit the tapered roller bearing outer race to the height shown in the illustration.