A/T FLUID CHANGE
If you have a A/T fluid changer, use this changer to replace the A/T fluid. If you do not have a A/T fluid changer, replace the A/T fluid by the following procedure. |
![]() |
3.Remove the drain plug from the bottom of the transmission case to drain the A/T fluid. Approximately 2.0 dm3 of A/T fluid should be removed. 4.Install the drain plug with a new gasket, and tighten it to the specified torque. Tightening torque: 32 ± 2 N·m 5.
Approximately 5.5 dm3 of A/T fluid should be added. 6.Repeat the procedure in Step 2. (to pump out the rest of the contaminated A/T fluid) 7.Add new A/T fluid (DIA QUEEN ATF J-2) through the oil filter tube. Approximately 3.5 dm3 of A/T fluid should be added.
|
![]() ![]() |
8.Reconnect the hose which was disconnected in step 1 above, and firmly insert the dipstick. 9.Start the engine and run it at idle for one to two minutes. 10.Move the selector lever through all positions, and then move it to the "N" position. |
![]() |
11.Check that the A/T fluid level is at the "C" mark on the dipstick. If the level is less than this, add A/T fluid. |
![]() |
12.Drive the vehicle until the A/T fluid temperature rises to the normal operating temperature [70 -
80°C], and then check the A/T fluid level again. The A/T fluid level must be at the "H" mark.
When the A/T fluid is greater than the specified level, drain the excess fluid through the drain plug to adjust the A/T fluid to the specified level. 14.Firmly insert the dipstick into the oil filler tube. |