Code No. U0415: ABS CAN data error






caution
  • If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, always diagnose the CAN bus lines.
  • Before replacing the ECU, ensure that the communication circuit is normal.

OPERATION




DIAGNOSIS CODE SET CONDITIONS




  • IG1 voltage: 10 V or more
  • If the received wheel speed of one or more wheels reaches or exceeds the threshold value of 4000 r/min, or the received wheel speed of one or more wheels is SNA.
    note SNA (Signal not available)

PROBABLE CAUSES


Current trouble
  • Wiring harness or connector failure between ASC-ECU and the stop lamp switch
  • Malfunction of the ABS sensor
  • Malfunction of the stop lamp switch
  • ASC-ECU malfunction
  • 4WD-ECU malfunction
Past trouble
  • Refer to "How to treat past trouble" (GROUP 00 - How to Treat Past Trouble ) for proceeding the diagnostics.

DIAGNOSIS PROCEDURE


STEP 1. M.U.T.-III CAN bus diagnostics


Use M.U.T.-III to diagnose the CAN bus lines.

Q. Is the check result normal?

Go to Step 2.
Repair the CAN bus line. (Refer to GROUP 54C - Troubleshooting .) Then go to Step 2.

STEP 2. M.U.T.-III data list


Check the following service data. (Refer to .)

  • Item 07: CAN system (ABS/ASC)
  • Item 16: FL wheel speed sensor
  • Item 17: FR wheel speed sensor
  • Item 18: RL wheel speed sensor
  • Item 19: RR wheel speed sensor

Q. Is the check result normal?

Go to Step 3.
Troubleshoot the ABS system. (Refer to GROUP 35C - Troubleshooting .)

STEP 3. Check the following connector:


Check the connectors below for improper engagement, terminal damage or terminal drawn in the connector case.

  • C-130 4WD-ECU connector
  • C-313, C-317 ETACS-ECU connector

Q. Are the connectors and terminals in good condition?

Go to Step 4.
Repair the connector(s) or terminal(s). Then go to Step 6.

STEP 4. Wiring harness check


Check the wiring harness between the C-130 4WD-ECU connector and the C-313 ETACS-ECU connector for damage or other problem.

Q. Is the wiring harness in good condition?

Go to Step 5.
Repair damage or other problem in the wiring harness. Then go to Step 6.

STEP 5. Check whether the diagnosis code is reset.


(1)Erase the diagnosis code.
(2)Turn the ignition switch from the LOCK (OFF) position to the ON position.
(3)Check if the diagnosis code is set.

Q. Is the diagnosis code No. U0415 set?

Replace 4WD-ECU. (Refer to .) Then go to Step 6.
This diagnosis is complete.

STEP 6. Check whether the diagnosis code is reset.


Q. Is the diagnosis code No. U0415 set?

Diagnose again from Step 1.
This diagnosis is complete.