REMOVAL AND INSTALLATION <4HN>



caution The part indicated * mark should be temporarily tightened and then should be fully tightened with the engine weight applied on the vehicle body.
Pre-removal operation
  • Battery and Battery Tray Removal
  • Air Cleaner Assembly and Air Cleaner Bracket Removal (Refer to GROUP 15 - Air Cleaner ).
  • Engine-ECU Removal (Refer to GROUP 13E - Engine-ECU ).

Post-installation operation
  • Engine-ECU Installation (Refer to GROUP 13E - Engine-ECU ).
  • Air Cleaner Assembly and Air Cleaner Bracket Installation (Refer to GROUP 15 - Air Cleaner ).
  • Battery and Battery Tray Installation





Removal steps


1.
Power steering pressure hose clamp
<<A>>

2.
Transmission mounting bracket


·
Transfer assembly removal (Refer to GROUP 22A - Transmission Assembly ).

>>A<<
3.
Transmission mounting insulator stopper


4.
Transmission mounting insulator

REMOVAL SERVICE POINT



<<A>> TRANSMISSION MOUNTING BRACKET ASSEMBLY REMOVAL



While supporting the engine and transmission assembly with a garage jack, remove the transmission mounting insulator assembly.

INSTALLATION SERVICE POINT



>>A<< TRANSMISSION MOUNTING INSULATOR STOPPER INSTALLATION



Install the transmission mounting insulator stopper as shown in the figure.