DISASSEMBLY AND REASSEMBLY







Disassembly steps


1.
Bleeder cap


2.
Bleeder


3.
Pad/wear indicator assembly (inner)


4.
Pad assembly (inner)


5.
Clip


6.
Pad/clip assembly (outer)


7.
Shim


8.
Lock pin


9.
Bushing


10.
Guide pin


11.
Caliper support


12.
Pin boot


13.
Boot ring
<<A>>

14.
Piston boot
<<A>>

15.
Piston
<<B>>

16.
Piston seal


17.
Caliper body
note
  • As for the pad set, the brake pads for both the right wheels and the left wheels have the wear indicator.
  • Install the pad & wear indicator assembly to the inner side of the brake disc, making sure that the wear indicator is located on the bottom.

LUBRICATION POINTS





DISASSEMBLY SERVICE POINTS



<<A>> PISTON BOOT/PISTON REMOVAL



caution Blow air gradually to remove the pistons. The pistons will rush out if a force of air is applied suddenly.
Cover the caliper body outer side with a cloth or similar materials. Blow compressed air through the brake hose installation area to remove the piston and piston boot.

<<B>> PISTON SEAL REMOVAL



1.
caution Do not use a flat-tipped screwdriver or similar tool to remove the piston seal. These may damage the inner side of the cylinder.
Remove the piston seal with your finger tip.
2.Clean the piston surface and cylinder inner face with alcohol or specified brake fluid.
Brake fluid: DOT 3 or DOT 4