REMOVAL AND INSTALLATION

			Wiper blade removal steps
		1.	Wiper blade assembly
	>>C<<	2.	Wiper blade
			Windshield wiper motor and link assembly removal steps
	>>B<<	3.	Wiper arm and blade assembly
		4.	Hood weatherstrip rear
		·	Fender inner garnish (Refer to GROUP 42A, Loose panel .)
		5.	Front deck garnish
		6.	Windshield wiper link
		7.	Wiper motor link plate
<<A>>	>>A<<	8.	Windshield wiper motor

note

For removal and installation of the wiper and washer switch, refer to GROUP 54A, Column switch

REMOVAL SERVICE POINT

1.Remove the wiper link rod joint from the wiper motor link plate.

2.Connect the wiper motor to a battery, and rotate the link plate as shown.
3.In this position, withdraw the link plate from the wiper link assembly.

1.Position the wiper motor link plate as shown, and assemble it to the wiper link assembly.

note

The link plate can be assembled to the wiper link assembly only at this position. If not, rotate the link plate to this position (Refer to Stop Position Check, ).
Wiper motor replacement parts are supplied with the link plate positioned as shown.

2.Connect the assembled wiper motor to a battery, and set it to the automatic stop position (Refer to Stop position check,

).
3.Apply grease to the inside of link rod joint (as required) and connect the link rod to wiper motor link plate.

Install the wiper arm and blade assembly at the specified positions.

(A): Φ 2 marking ± 5 mm

caution

Use a curved backing like that shown for the backing of a wiper blade to ensure sustained wiper wiping performance.