Code No.B2464 Multi information meter switch seizure
caution | Whenever the ECU is replaced, ensure that the communication circuit is normal. |



TROUBLE JUDGMENT
PROBABLE CAUSES
- Damaged harness wires and connectors
- Malfunction of multi information meter switch
- Malfunction of combination meter
DIAGNOSIS PROCEDURE |
STEP 1. Connector check: C-02 multi information meter switch connector |
Q.
Is the check result normal?
|
![]() |
|
![]() |
|
STEP 2. Multi information meter switch check |
Check the multi information meter switch. Refer to ![]() |
Q.
Is the check result normal?
|
![]() |
|
![]() |
|
STEP 3. Resistance measurement at the C-02 multi information meter switch connector |
(1)Disconnect the multi information meter switch connector, and then measure at the wiring harness side. |
(2)Measure the resistance from C-02 multi information meter switch connector terminal No. 4 to body earth. OK: Continuity exists (2 Ω or less) |
Q.
Is the check result normal?
|
![]() |
|
![]() |
|
STEP 4. Check the wiring harness between the C-02 multi information meter switch connector terminal No. 4 and the body earth. |
Q.
Is the check result normal?
|
![]() |
|
![]() |
|
STEP 5. Connector check: C-03 combination meter connector |
Q.
Is the check result normal?
|
![]() |
|
![]() |
|
STEP 6. Check the wiring harness between the C-03 combination meter connector terminal No. 3 and the C-02 multi information meter switch terminal No. 1. |
Q.
Is the check result normal?
|
![]() |
|
![]() |
|
STEP 7. Check whether the diagnosis code is reset. |
Check again if the diagnosis code is set to the combination meter. |
(1)Erase the diagnosis code. |
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position. |
(3)Check if diagnosis code is set. |
Q.
Is the diagnosis code set?
|
![]() |
|
![]() |
|