Inspection Procedure 2: Any of the Tail lamps does not Illuminate.













COMMENTS ON TROUBLE SYMPTOM




PROBABLE CAUSES



  • Malfunction of rear combination lamp unit
  • Damaged harness wires and connectors

DIAGNOSIS PROCEDURE


STEP 1. Connector check: D-10 (RH) and D-15 (LH) rear combination lamp connectors


Q. Is the check result normal?





STEP 2. Resistance measurement at the D-10 (RH) and D-15 (LH) rear combination lamp connectors


(1)Disconnect the connector, and measure at the wiring harness side.
(2)Measure the resistance between the connector of lamp which does not illuminate and the body earth.

  • Measure the resistance between the D-10 (RH) and D-15 (LH) rear combination lamp connector terminal No. 4 and the body earth.
OK: Continuity exists (2 Ω or less)

Q. Is the check result normal?





STEP 3. Wiring harness check between the D-10 (RH) and D-15 (LH) rear combination lamp connector terminal No. 4 and the body earth.



  • Check the earth wires for open circuit.

Q. Is the check result normal?





STEP 4. Connector check: C-311 ETACS-ECU connector


Q. Is the check result normal?





STEP 5. Wiring harness check between the D-10 (RH) and D-15 (LH) rear combination lamp connector terminal No. 2 and the C-311 ETACS-ECU connector terminal No. 13 <RH> or 10 <LH>



  • Check the output lines for open circuit.

Q. Is the check result normal?





STEP 6. Retest the system



Q. Is the check result normal?