GENERAL INFORMATION








  • Automatically active system by select reverse position
  • Depending on whether the vehicle is equipped with a towing bar, you can change sensors between the standard mode and the towing bar mode. The towing bar mode changes the system to exclude in the area in which the towing is mounted from the detection areas.
note The detection range of the sensor varies with temperature and humidity. Obstacles below the bumpers or a curbstone not taller than the sensor position may be hard to be detected.

OPERATION



ACTIVATION/DEACTIVATION OF REVERSING SENSOR SYSTEM



By shifting the gear to the reverse position and operating the sonar switch, the system can be turned ON (reversing sensor indicator: ON) and OFF (reversing sensor indicator: OFF).

THE TOWING BAR MODE SWITCHING




BUZZER DURATION



Distance between back sensor and obstacles
Buzzer duration
The standard mode
The towing bar mode
Less than approximately 40 cm


Buzzer: OFF
Approximately 40 to 60 cm




Approximately 60 to 80 cm




Approximately 80 to 100 cm




Approximately 100 to 120 cm




Approximately 120 to 150 cm




Distance between corner sensor and obstacles
Buzzer duration
Less than approximately 25 cm


Approximately 25 to 40 cm


Approximately 40 to 50 cm



FAIL-SAFE FUNCTION



  1. When the ultrasonic noise is received, the bass toned buzzer sound continuously. When the ultrasonic noise stops, the normal operation will be resumed immediately.
  2. When the abnormality such as the open circuit of a sensor occurs, the sensor turns OFF and the high toned buzzer sounds for 5 seconds. When the normal signal is received, the normal state will be resumed.
  3. When an abnormality occurs in the system, the reversing sensor indicator keeps flashing with 0.8-second interval until the system returns to the normal condition. However, if the system is turned OFF by using the switch, the indicator stops its flashing.