1.Before inspection, set the vehicle to the pre-inspection condition.
2.Turn the ignition switch to the "LOCK" (OFF) position and then connect the M.U.T.-III to the diagnosis connector (Refer to GROUP 00 - Precautions Before Service - M.U.T.-III Sub Assembly ).

3.Set a timing light to the power supply line (terminal No. 3) of the ignition coil No. 1.
note The power supply line is looped and also longer than the other ones.
4.Start the engine and let it run at idle.
5.Select engine data list item No. 2 on the M.U.T.-III to measure engine idle speed and check that it is approximately 650 r/min.
6.Select engine actuator test item No. 11 on the M.U.T.-III, and set the ignition timing to the basic ignition timing.
7.Check that basic ignition timing is within the standard value.
Standard value: 5° BTDC ± 3°
8.If the basic ignition timing is outside the standard value, inspect the MPI system (Refer to GROUP 13C - Troubleshooting - Inspection Chart for Trouble Symptoms ).
caution If the test is not cancelled, a forced driving will continue for 27 minutes. Driving under this condition may damage the engine.
Cancel the engine actuator test item No. 11, Basic ignition timing set mode, on the M.U.T.-III.
10.Check that ignition timing is at the standard value.
Standard value: approximately 10° BTDC
  • The ignition timing may fluctuate within ± 7°. This is normal.
  • In higher altitude, the ignition timing is more advanced than the standard value by approximately 5°.
  • Wait till approximately 1 minute passes after the engine started, and check the ignition timing when the engine stabilized.
11.Remove the timing light.
12.Turn the ignition switch to the "LOCK" (OFF) position and then disconnect the M.U.T.-III.