Code No. P0428: No. 2 Exhaust Gas Temperature Sensor (Catalyst Temperature) Circuit High Input




OPERATION




FUNCTION




TROUBLE JUDGMENT


Check Conditions
Judgment Criterion

FAIL-SAFE AND BACKUP FUNCTION




PROBABLE CAUSES




DIAGNOSTIC PROCEDURE


STEP 1. M.U.T.-III data list



  • Refer to Data List Reference Table

  1. Item 118: No. 2 exhaust gas temperature sensor (catalyst temperature)

Q. Is the check result normal?

Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
Go to Step 2.

STEP 2. Check No. 2 exhaust gas temperature sensor (catalyst temperature) itself.



  • No. 2 exhaust gas temperature sensor (catalyst temperature) connector check.
  • Check No. 2 exhaust gas temperature sensor (catalyst temperature) itself (Refer to GROUP 17 - Emission Control <DIESEL> - Diesel Particulate Filter (DPF) System - No. 2 Exhaust Gas Temperature Sensor (catalyst temperature) Check ).

Q. Is the check result normal?

Go to Step 3.
Repair or replace the connector, or replace the No. 2 exhaust gas temperature sensor (catalyst temperature). After replacing the No. 2 exhaust gas temperature sensor (catalyst temperature), carry out the forcible DPF regeneration. (Refer to GROUP 17 - Emission Control <DIESEL> - Diesel Particulate Filter (DPF) System - Forcible DPF Regeneration ).

STEP 3. Perform voltage measurement at No. 2 exhaust gas temperature sensor (catalyst temperature) connector.



  • Disconnect connector, and measure at harness side.
  • Ignition switch: ON
  • Voltage between terminal engine-ECU DTS2 line and body earth.
OK: 4.5 - 4.9 V

Q. Is the check result normal?

Go to Step 6.
Go to Step 4.

STEP 4. Check harness between No. 2 exhaust gas temperature sensor (catalyst temperature) connector terminal and engine-ECU connector terminal DTS2.



  • Check output line for open circuit.

Q. Is the check result normal?

Go to Step 5.
Repair or replace the connector, or repair the damaged harness wire.

STEP 5. M.U.T.-III data list



  • Refer to Data List Reference Table

  1. Item 118: No. 2 exhaust gas temperature sensor (catalyst temperature)

Q. Is the check result normal?

Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
Replace the engine-ECU.

STEP 6. Perform resistance measurement at No. 2 exhaust gas temperature sensor (catalyst temperature) connector.



  • Disconnect connector, and measure at harness side.
  • Resistance between terminal engine-ECU DT2E line and body earth.
OK: Continuity (2 Ω or less)

Q. Is the check result normal?

Go to Step 8.
Go to Step 7.

STEP 7. Check harness between No. 2 exhaust gas temperature sensor (catalyst temperature) connector terminal and engine-ECU connector terminal DT2E.



  • Check earthing line for open circuit and damage.

Q. Is the check result normal?

Go to Step 5.
Repair or replace the connector, or repair the damaged harness wire.

STEP 8. Check harness between No. 2 exhaust gas temperature sensor (catalyst temperature) connector terminal and engine-ECU connector terminal DTS2.



  • Check output line for damage.

Q. Is the check result normal?

Go to Step 5.
Repair or replace the connector, or repair the damaged harness wire.