1.Remove the caliper assembly and the brake disc. Retain the caliper assembly with a wire and the like to prevent from falling.
2.Turn the hub a few times to seat the bearing.

3.Wind a rope around the hub bolt and turn the hub by pulling at a 90 degree angle with a spring balance. Measure to determine whether or not the rotary-sliding resistance of the rear hub is at the limit.
Limit: 24.5 N
4.Replace the rear hub assembly if the rotary-sliding resistance cannot be made to within the limit.
5.After having finished the inspection, install the brake disc, caliper assembly and tighten the caliper assembly mounting bolts to the specified torque.
Tightening torque: 58 ± 7 N·m