DIAGNOSIS CODE CHART


caution
  • During diagnosis, a diagnosis code associated with other system may be set when the ignition switch is turned on with connector(s) disconnected. On completion, confirm all systems for diagnosis code(s). If diagnosis code(s) are set, erase them all.
  • If the combination meter needs to be replaced as a result of troubleshooting, the current driving distance and elapsed days must be entered into the meter after the replacement in order to be used for service reminder function. Therefore, read "Integrated mileage for reminder," "Integrated days for reminder," "Mileage until Extra reminder," "Months until Extra reminder," and "Current schedule" from the meter before the replacement using the special function of M.U.T.-III, and note them. For the operation method of M.U.T.-III, refer to . If "Integrated mileage for reminder" or "Integrated days for reminder" cannot be read from the meter using M.U.T.-III, use the following method.

  1. As for the driving distance for check warning, use the driving distance displayed on the multi information display.
  2. As for the elapsed days for check warning, calculate the number of elapsed days from the delivery date to the customer (service reminder function start date) and current date.
Diagnosis code No.
Diagnostic item
Reference page
B1200
Odometer failure

B1201
Fuel information problem

B1209
Test mode

B2463
Rheostat switch sticking

B2464
Meter information SW sticking <High contrast meter>

U0100
Engine CAN timeout

U0141
ETACS CAN timeout

U0164
A/C CAN timeout/Not equipped

U0168
WCM/KOS CAN timeout

U0184
AUDIO CAN timeout

U0230
Power Gate CAN timeout

U0245
AND CAN timeout

U1000
OSS CAN timeout

U1005
Corner/Back SNS.ECU CAN timeout

U1190
No receive fault detect signal

U1195
Coding not completed