Code No.U1190 No receive fault detect signal



caution
  • If the diagnosis code No. U1190 is set, be sure to diagnose the CAN bus line.
  • Before replacing the ECU, ensure that the power supply circuit, the earth circuit and the communication circuit are normal.

DIAGNOSTIC FUNCTION




JUDGEMENT CRITERIA


Check Conditions
  • When all the following conditions are met.

  1. Power supply mode: ON
  2. ETACS-ECU system voltage is at 10 to 16 V.
Judgment Criterion
  • After the following condition is met, 5 seconds or more have elapsed.

  1. CAN signal from the ETACS-ECU cannot be received.

PROBABLE CAUSES



  • Malfunction of the CAN bus
  • Malfunction of ETACS-ECU
  • Malfunction of the LDW-ECU

DIAGNOSIS PROCEDURE


STEP 1. M.U.T.-III CAN bus diagnostics



Q. Is the check result normal?





STEP 2. M.U.T.-III other system diagnosis code



Q. Is the diagnosis code set?





STEP 3. M.U.T.-III other system diagnosis code



Q. Is the diagnosis code set?





STEP 4. Check whether the diagnosis code is reset.



(1)Erase the diagnosis code.
(2)Turn the engine switch from the LOCK (OFF) position to the ON position.
(3)Check if the diagnosis code is set.

Q. Is the diagnosis code set?





STEP 5. Check whether the diagnosis code is reset.



(1)Erase the diagnosis code.
(2)Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3)Check if the diagnosis code is set.

Q. Is the diagnosis code No.U1190 set?