REAR WIPER AND WASHER



CONSTRUCTION DIAGRAM





note *: Using the customise function, the fixed interval type intermittent wiper, reverse gear-linked rear wiper function and the washer-linked wiper function can be adjusted (Refer to ).

DESCRIPTION OF CONSTRUCTION AND OPERATION



Rear wiper control <Initial condition: Front or rear wiper switch ON>




When the rear wiper switch on the column switch is turned ON while the ignition switch is in ACC or ON position, ETACS turns the rear wiper relay ON for 3 seconds (for approximately 2 cycles) and operates the intermittent action in 8 seconds interval.
When the selector lever is moved to R (reverse) position during the front or rear wiper operation, the inhibitor switch R (reverse) turns ON, and 1 second after that, ETACS turns the rear wiper relay ON for 3 seconds (for approximately 3 cycles), and operates the intermittent action in 8 seconds interval again.
note Using the customise function, the operation with front/rear wiper ON can be switched to the operation with the rear wiper only ON. (Refer to .)

Washer-linked rear wiper function <Initial condition: with function>




When the rear washer switch on the column switch is turned ON while the ignition switch is in ACC or ON position, ETACS turns the rear washer relay ON.
The rear washer relay turns ON after the rear washer switch has been ON for 0.3 seconds, then turns the rear wiper relay ON to operate the rear wiper simultaneously. When the rear washer switch is turned OFF, after 3 seconds the rear wiper is turned OFF.
If the rear washer switch is turned ON during the rear wiper operation, 7.4 seconds after turning OFF the rear wiper relay turns OFF, the intermittent action is resumed in 8 seconds interval.
note Using the customise function, the washer linked rear wiper function can be invalidated (Refer to ).