FENDER SHIELD







note Refer to the Front End Crossmember section on for the welding point with headlamp support panel lower.







NOTE ON REPAIR WORK



REMOVAL



Turn up the front sidemember outer as shown to cut off the welded point between the front sidemember inner and the front body frame to side sill brace.

INSTALLATION



Before installing a new front sidemember, remove the front floor sidemember from the existing front sidemember. The welding point between the front sidemember inner and the front body frame-to-side sill brace is not visible from the front sidemember outer. Drill a hole into the front sidemember outer at the same point as the welding point which is visible from the front sidemember inner. Then cut the welding point from front body frame-to-side sill brace. Then weld the front sidemember inner to the front body frame-to-side sill brace and the front sidemember outer.