QUARTER INNER



caution When repairing the area using sound dampening foam material do not use firing tools since the sound dampening foam material may burn.





note Refer to the Quarter Outer section on for the welding points with the quarter outer.

NOTE ON REPAIR WORK



INSTALLATION



1.When installing the new quarter panel upper inner parts, machine the body loose panel cushion (MR565301 or MR435765) for replacement as shown and apply it to the quarter panel upper inner parts because the sound dampening foam material cannot be filled into the quarter panel upper inner.

2.When installing the new rear pillar reinforcement lower part, machine the body loose panel cushion (MR565301 or MR435765) for replacement as shown and apply it to the rear pillar reinforcement lower part because the sound dampening foam material cannot be filled into the rear pillar reinforcement lower.

3.When installing the new gate pillar reinforcement parts, in order to prevent the dripping of sound dampening foam material to be filled into the gate pillar in the next process, install the rear end silencer side to the gate pillar lower bulkhead, and then apply the butyl-tape to close the gap of the rear end silencer side.

4.After installing the quarter panel extension rear lower, seal the hole and flange with sheet-metal tape, and then fill the hole with the sound dampening foam material as shown in the figure of the instructions.
Sound dampening foam material: 3M ATD Part No.08463

5.Wait 2 hours after filling the sound dampening foam material to remove the bolt and aluminium tape, then melt the sound dampening foam material with a soldering gun so a clip, etc. can thoroughly be inserted in the hole filled with sound dampening foam material.