SUPPORT LOCATIONS FOR LIFTING AND JACKING <EXCEPT PHEV>



SUPPORT POSITIONS FOR A GARAGE JACK


caution
  • Be sure to support the specified locations only. Otherwise, deformation of vehicle may occur.
  • Be careful to avoid damage to the front under cover or rear differential carrier assembly.



SUPPORT POSITIONS FOR AXLE STANDS, SINGLE-POST LIFT OR DOUBLE-POST LIFT


caution
  • If rubber attachments with grooves that are too thick are used at the front support positions, the front fender may become bent, so be sure to use rubber attachments with groove thicknesses of 18 mm or less.

  • If attachments which are not high enough are used, they may damage areas such as the side step. Be sure to use attachments which are high enough, or remove the side step if not using attachments.



SUPPORT POSITIONS FOR A PLATE TYPE LIFT




Support the notch with a spacer (100-mm width, 100-mm height and 200-mm depth).