REDUCE PRESSURIZED FUEL LINES


When removing the fuel pipes and fuel hoses, follow the procedure below to release fuel pressure in the line and prevent fuel from running out, because fuel pressure in the fuel line is high.
1.Remove the second seat assembly (Refer to GROUP 52A - Second Seat Assembly ).

2.Remove the floor inspection lid (RH).

3.Disconnect the fuel pump and gauge assembly connector.
4.Run the engine at the continuous idling mode. (Refer to GROUP 00 - Precautions Before Service, continuous idling mode ).
note
  • If the engine starts, wait until it stops. Then turn off the electric motor switch.
  • If the engine does not start, turn off the electric motor switch.
5.Connect the fuel pump and gauge assembly connector.
6.Install the floor inspection lid (RH).
7.Install the second seat assembly (Refer to GROUP 52A - Second Seat Assembly ).