Inspection Procedure 9: The Engine Stalls when Starting the Car (pass out), The Engine Stalls when Decelerating




COMMENTS ON TROUBLE SYMPTOM




PROBABLE CAUSES




DIAGNOSIS PROCEDURE


STEP 1. M.U.T.-III diagnosis code


Q. Is the diagnosis code set?

Inspection chart for diagnosis code (Refer to ).
Go to Step 2.

STEP 2. M.U.T.-III data list



  • Refer to Data List Reference Table .

  1. Item 11: Accelerator pedal position sensor (main)
  2. Item 12: Accelerator pedal position sensor (sub)
  3. Item 13: Throttle position sensor (main)
  4. Item 15: Throttle position sensor (sub)

Q. Are the check results normal?

YES : Go to Step 3.
Perform the diagnosis code classified check procedure for the sensor that has shown an abnormal data value (Refer to Inspection Chart for Diagnosis Code ).

STEP 3. Check air intake from intake hose and inlet manifold.


Q. Is the check result normal?

Go to Step 4.
Repair.

STEP 4. Check throttle body (throttle valve portion) contamination.


Q. Is the check result normal?

Go to Step 5.
Clean throttle body (throttle valve portion) (Refer to ).

STEP 5. Visual check of ignition spark.



  • Remove the spark plug and install it to the ignition coil.
  • Connect the ignition coil connector.
  • Disconnect all injector connectors.
  • At the engine start, check each spark plug produces a spark.

Q. Is the check result normal?

Replace the engine-ECU.
Check Inspection Procedure - ignition circuit system (Refer to ).