Code No. P2127: Accelerator Pedal Position Sensor (sub) Circuit Low Input




OPERATION




FUNCTION




TROUBLE JUDGMENT


Check Condition
Judgement Criterion

FAIL-SAFE AND BACKUP FUNCTION




PROBABLE CAUSES




DIAGNOSIS PROCEDURE


STEP 1. M.U.T.-III data list



  • Data list reference table (Refer to ).

  1. Item 12: Accelerator pedal position sensor (sub)

Q. Is the check result normal?

Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
Go to Step 2.

STEP 2. Perform voltage measurement at accelerator pedal position sensor connector.



  • Disconnect connector, and measure at harness side.
  • Ignition switch: "ON"
  • Voltage between terminal engine-ECU 5VV and body earth.
OK: 4.9 - 5.1 V

Q. Is the check result normal?

Go to Step 5.
Go to Step 3.

STEP 3. Check harness between accelerator pedal position sensor connector terminal and engine-ECU connector terminal 5VV.



  • Check power supply line for open/short circuit.

Q. Is the check result normal?

Go to Step 4.
Repair or replace the connector, or repair the damaged harness wire.

STEP 4. M.U.T.-III data list



  • Data list reference table (Refer to ).

  1. Item 12: Accelerator pedal position sensor (sub)

Q. Is the check result normal?

Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
Replace the engine-ECU.

STEP 5. Check harness between accelerator pedal position sensor connector terminal and engine-ECU connector terminal 5VV.



  • Check power supply line for damage.

Q. Is the check result normal?

Go to Step 6.
Repair or replace the connector, or repair the damaged harness wire.

STEP 6. Check harness between accelerator pedal position sensor connector terminal and engine-ECU connector terminal APSS.



  • Check output line for open/short circuit and damage.

Q. Is the check result normal?

Go to Step 7.
Repair or replace the connector, or repair the damaged harness wire.

STEP 7. Replace the accelerator pedal assembly



  • After replacing the accelerator pedal assembly, reconfirm whether the diagnosis code is set.

Q. Is the diagnosis code set?

Replace the engine-ECU.
Check end.