Code No. P2455: Exhaust Differential Pressure Sensor Circuit High Input




OPERATION




FUNCTION




TROUBLE JUDGMENT


Check Conditions
Judgment Criterion

FAIL-SAFE AND BACKUP FUNCTION




PROBABLE CAUSES




DIAGNOSTIC PROCEDURE


STEP 1. M.U.T.-III data list



  • Refer to Data List Reference Table .

  1. Item 120: Exhaust differential pressure sensor

Q. Is the check result normal?

Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
Go to Step 2.

STEP 2. Perform resistance measurement at exhaust differential pressure sensor connector.



  • Disconnect connector, and measure at harness side.
  • Ignition switch: ON
  • Resistance between terminal engine-ECU DDPE line and body earth.
OK: Continuity (2 Ω or less)

Q. Is the check result normal?

Go to Step 5.
Go to Step 3.

STEP 3. Check harness between exhaust differential pressure sensor connector terminal and engine-ECU connector terminal DDPE.



  • Check earthing line for open circuit and damage.

Q. Is the check result normal?

Go to Step 4.
Repair or replace the connector, or repair the damaged harness wire.

STEP 4. M.U.T.-III data list



  • Refer to Data List Reference Table .

  1. Item 120: Exhaust differential pressure sensor

Q. Is the check result normal?

Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
Replace the engine-ECU.

STEP 5. Replace the exhaust differential pressure sensor



  • After replacing the exhaust differential pressure sensor, Carry out the forcible DPF regeneration. (Refer to GROUP 17 - Emission Control <DIESEL> - Diesel Particulate Filter (DPF) System - Forcible DPF Regeneration ). After carrying out the forcible DPF regeneration, reconfirm diagnosis code.

Q. Is the diagnosis code set?

Go to Step 4.
Check end.