REMOVAL AND INSTALLATION
<4B1-PHEV>



Pre-removal Operation
  • Engine room under cover A, B removal (Refer to GROUP 51 <PHEV> - Under Cover ).
  • Engine coolant draining (Refer to ).
  • Air cleaner intake duct and air cleaner assembly removal (Refer to GROUP 15 - Air Cleaner <4B1-PHEV>).
  • EV Radiator Condenser Tank Removal (Refer to GROUP 14B - EV Radiator/EV Radiator Condenser Tank ).

Post-installation Operation
  • EV Radiator Condenser Tank Installation (Refer to GROUP 14B - EV Radiator/EV Radiator Condenser Tank )
  • Air cleaner intake duct and air cleaner assembly installation (Refer to GROUP 15 - Air Cleaner <4B1-PHEV>).
  • Engine coolant refilling (Refer to ).
  • Engine room under cover A, B Installation (Refer to GROUP 51 <PHEV> - Under Cover ).





Removal steps


1.
Radiator drain plug


2.
O-ring


3.
Radiator cap


4.
Radiator condenser tank hose


5.
Radiator condenser tank
<<A>>
>>A<<
6.
Hose clip
<<A>>
>>A<<
7.
Radiator upper hose
<<A>>
>>A<<
8.
Hose clip
<<A>>
>>A<<
9.
Hose clip
<<A>>
>>A<<
10.
Radiator lower hose
<<A>>
>>A<<
11.
Hose clip


·
Radiator fan motor connector connection


·
Condenser fan motor connector connection


12.
Fan, fan motor and fan shroud assembly


·
Front end upper bar assembly (Refer to GROUP 42A - Loose Panel )


13.
Support upper insulator


·
Condenser assembly (Refer to GROUP 55 - Condenser Assembly )


14.
Radiator assembly


15.
Support lower insulator


16.
Radiator fan


17.
Cooling fan controller


18.
Radiator fan motor


19.
Condenser fan


20.
Cooling fan controller


21.
Condenser fan motor


22.
Fan shroud

REMOVAL SERVICE POINTS



<<A>> HOSE CLIP/RADIATOR HOSE REMOVAL



1.Make mating marks on the radiator hose and the hose clip as shown to install them in the original position.

2.Break off the tip of hose clip claw and spread out the hose clip, then disconnect the radiator hose.
note If there is a hose clip claw, the hose clip cannot spread to capacity because the claw contacts the hose clip.

INSTALLATION SERVICE POINTS



>>A<< RADIATOR HOSE/HOSE CLIP CONNECTION


1.
caution Never reuse the hose clip whose claw is broken off to prevent the rusting.
Make mating mark on a new hose clip in the same position as the remove one.

2.Insert the radiator hose until the protrusion of the pipe.
3.Align the mating marks on the radiator hose and hose clip.
4.Remove the hose clip claw and shorten the hose clip, then install the radiator hose.