REMOVAL AND INSTALLATION



caution
  • If the electric water pump is dropped, do not reuse that electric water pump.
  • Do not operate the electric water pump when the motor coolant is empty. If the electric water pump is operated, the electric water pump service life may be reduced. Therefore, do not reuse that electric water pump.
Pre-removal and post-installation operation
  • Motor Coolant Draining and refilling (Refer to ).
  • Engine Room Under Cover Front A, B Removal and Installation (Refer to GROUP 51 - Under Cover <PHEV>).
  • Front Bumper Assembly Removal and Installation (Refer to GROUP 51 - Front Bumper Assembly ).





Removal steps
<<A>>
>>A<<
1.
EV radiator condenser tank hose B connection
<<A>>
>>A<<
2.
EV radiator piping hose F connection


3
Harness connection


4.
Electric water pump

REMOVAL SERVICE POINTS



<<A>> EV RADIATOR CONDENSER TANK HOSE AND EV RADIATOR PIPING HOSE REMOVAL



Make mating marks on the hose and the hose clip as shown to install them in the original position.

INSTALLATION SERVICE POINT



>>A<< EV RADIATOR CONDENSER TANK HOSE AND EV RADIATOR PIPING HOSE CONNECTION


caution A broken hose clip should not be reused as it will rust.
1.Make mating mark on a new hose clip in the same position as the remove one.

2.Insert the hose until the protrusion of the fitting.
3.Align the mating marks on the hose and hose clip.