REMOVAL AND INSTALLATION <REAR>



Pre-removal and post-installation operation
  • Motor Coolant Draining and refilling (Refer to ).
  • Cargo Floor Box Removal and Installation (Refer to GROUP 52A - Interior Trim ).
  • EV Control Unit Cover, EV Motor Control Unit Cover Removal and Installation (Refer to GROUP 54D - On Board Charger (OBC)/DC-DC Converter ).





Removal steps
<<A>>
>>A<<
1.
EV radiator pipe G
<<A>>
>>A<<
2.
EV radiator piping hose S


3.
Earth bolt
<<A>>
>>A<<
4.
EV radiator pipe H
<<A>>
>>A<<
5.
EV radiator piping hose N
<<A>>
>>A<<
6.
EV radiator piping hose L
<<A>>
>>A<<
7.
EV radiator pipe J
<<A>>
>>A<<
8.
EV radiator piping hose Q
<<A>>
>>A<<
9.
EV radiator piping hose P

REMOVAL SERVICE POINTS



<<A>> EV RADIATOR CONDENSER TANK HOSE AND EV RADIATOR PIPING HOSE REMOVAL



Make mating marks on the hose and the hose clip as shown to install them in the original position.

INSTALLATION SERVICE POINT



>>A<< EV RADIATOR CONDENSER TANK HOSE AND EV RADIATOR PIPING HOSE CONNECTION


caution A broken hose clip should not be reused as it will rust.
1.Make mating mark on a new hose clip in the same position as the remove one.

2.Insert the hose until the protrusion of the fitting or pipe.
3.Align the mating marks on the hose and hose clip.