REMOVAL AND INSTALLATION



caution When the EV oil cooler is removed, install the oil level plug and then add the oil of approx. 0.45 dm3. (The total oil capacity is approx. 2.2 dm3)
Pre-removal and post-installation operation
  • Oil Draining and refilling (Refer to .)
  • Headlamp Support Upper Panel Cover and Radiator Grille Removal and Installation (Refer to GROUP 51 - Radiator Grille ).
  • Latch Cover and Front Bumper Side Reinforcement A Removal and Installation (Refer to GROUP 42A - Loose Panel ).
  • Hood Latch Removal and Installation (Refer to GROUP 42A - Hood ).





Removal steps
<<A>>
>>A<<
1.
EV oil cooler hose D connection
<<A>>
>>A<<
2.
EV oil cooler hose E connection


3.
EV oil cooler lower bracket


4.
EV oil cooler upper bracket


5.
EV oil cooler

REMOVAL SERVICE POINTS



<<A>> EV OIL COOLER HOSE REMOVAL



Make mating marks on the hose and the hose clip as shown to install them in the original position.

INSTALLATION SERVICE POINT



>>A<< EV OIL COOLER HOSE CONNECTION


caution A broken hose clip should not be reused as it will rust.
1.Make mating mark on a new hose clip in the same position as the remove one.

2.Insert the hose until the protrusion of the fitting.
3.Align the mating marks on the hose and hose clip.