Inspection Procedure 3: When the Selector Lever is Set to "N" Position, Cruise Control is not Cancelled. <CVT>




OPERATION


When the selector lever is operated, the selector lever position signal from the inhibitor switch is sent to the CVT-ECU. Engine-ECU receives the selector lever position signal from the CVT-ECU via the CAN bus line.

COMMENTS ON TROUBLE SYMPTOM




PROBABLE CAUSES




DIAGNOSIS PROCEDURE


caution
  • If there is any problem in the CAN bus lines, an incorrect diagnosis code may be stored. Prior to this diagnosis, diagnose the CAN bus lines.
  • Before replacing the ECU, ensure that the CAN bus lines is normal.

STEP 1. Check the CAN bus system diagnosis.


Using M.U.T.-III, perform CAN bus diagnosis (Refer to GROUP 54C - Explanation About The M.U.T.-III Can Bus Diagnostics ).

Q. Is the check result satisfactory?

Go to Step 2.
Repair the CAN bus lines (Refer to GROUP 54C - Troubleshooting, Can Bus Diagnostic Table ). Then go to Step 5.

STEP 2. Check the data list.


Using M.U.T.-III, check the data list (Refer to data list reference table ).

  • Item 88: Inhibitor switch

Q. Is the check result normal?

Go to Step 3.
Check the CVT system (Refer to GROUP 23A - Troubleshooting, Inspection Procedures for Diagnosis Code, Code No.P0705: Malfunction of Inhibitor Switch ). Then go to Step 5.

STEP 3. Check the CVT system diagnosis code.


Using M.U.T.-III, perform CVT system diagnosis code (Refer to GROUP 23A - Troubleshooting, Diagnosis Function ).

Q. Is any diagnosis code stored?

Repair the CVT system (Refer to GROUP 23A - Troubleshooting, Diagnosis Code Chart ). Then go to Step 5.
Go to Step 4.

STEP 4. Check the symptom.


Q. When the selector lever is set to "N" position, is the cruise control cancelled?

It can be assumed that this malfunction is intermittent (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points, How to Cope with Intermittent Malfunction ).
Replace the engine-ECU (Refer to GROUP 13A - Engine-ECU <4B1>, GROUP 13C - Engine-ECU <4J1>). Then go to Step 5.

STEP 5. Check the symptom.


Q. When the selector lever is set to "N" position, is the cruise control cancelled?

The procedure is complete.
Return to Step 1.