INSPECTION



SELECTOR LEVER ASSEMBLY CHECK



Observe the following chart to check the selector lever assembly. If defective, replace the selector lever assembly.

  • To measure the voltage, connect the connector to the selector lever assembly. Then turn on the power supply mode of the electric motor switch to measure the voltage at the wiring harness side.
Terminal number
Item
Selector lever position
Standard value
7 - 8
Shift sensor (main)
Is not operated
2.3 - 2.7 V
Is held at N position
Is held at R position
0.59 - 1.49 V
Is held at D position
3.5 - 4.4 V
Is held at B position
3 - 4
Shift sensor (sub)
Is not operated
2.3 - 2.7 V
Is held at N position
Is held at R position
3.5 - 4.4 V
Is held at D position
0.59 - 1.49 V
Is held at B position
5 - 9
Select sensor (main)
Is not operated
2.32 - 2.57 V
Is held at N position
4.27 - 4.39 V
Is held at R position
Is held at D position
Is held at B position
2.32 - 2.57 V
1 - 10
Select sensor (sub)
Is not operated
2.32 - 2.57 V
Is held at N position
4.27 - 4.39 V
Is held at R position
Is held at D position
Is held at B position
2.32 - 2.57 V

ELECTRICAL PARKING SWITCH CHECK



Observe the following chart to check the electric parking switch. If defective, replace the electric parking switch.
Terminal number
Item
Electrical parking switch operation
Normal conditions
Continuity (Resistance)
Illumination/extinction
4 - 5
Electrical parking switch (main)
Don not press the switch
Continuity exists (150 - 170 Ω)
-
Press and hold the switch
Continuity exists (5.9 - 6.6 kΩ)
-
6 - 7
Electrical parking switch (sub)
Don not press the switch
Continuity exists (5.9 - 6.6 kΩ)
-
Press and hold the switch
Continuity exists (150 - 170 Ω)
-
1 - 4
Indicator
-
No continuity
Connect the connector to the electric parking switch. When the power supply mode of the electric motor switch is on or the ready indicator illuminates, the indicator must illuminate.
Connect the connectors to the electric parking switch and the selector lever assembly. When the power supply mode of the electric motor switch is turned on with the brake pedal depressed and the selector lever is tilted towards N position, the indicator must go out.
3 - 8
Illumination
-
No continuity
Connect the connector to the electric parking switch. When the taillamps illuminate, "P" must illuminate.