REMOVAL AND INSTALLATION


caution
  • After replace the front transaxle assembly, disconnect the negative terminal of the auxiliary battery for initialise the electrical parking driver unit, and check the electrical parking lock initial learning quantity. (Refer to GROUP22D - Electrical Parking Driver Unit ).
  • If the auxiliary battery is disconnected, the control timer which operates the engine forcibly will be reset. If the engine does not start for prolonged period after the reset, the fuel injection system may be clogged. To avoid this, press the battery charging switch to start the engine. Note that the battery charging switch may not be turned on if the drive battery is almost fully charged. In that case, wait until the drive battery is partially discharged.





Removal steps


·
Engine assembly (Refer to GROUP 11G - Engine Assembly ).


·
Front motor (Power unit) assembly (Refer to GROUP 54D - Motor (Power Unit) <Front> ).


·
Generator (Refer to GROUP 54D - Generator ).


1.
Control wiring harness connection


2.
Wiring harness connector connection


3.
Water pipe bracket


4.
Roll rod adapter bracket

>>A<<
5.
Front transaxle assembly

INSTALLATION SERVICE POINT



>>A<< FRONT TRANSAXLE ASSEMBLY INSTALLATION



1.Use a brush to apply the specified grease to the spline of the peak torque limiter.
note Wipe off excessive grease.
Grease
Brand name: 0101011 or equivalent
2.Install the front transaxle assembly.