TRANSAXLE FLUID CHANGE




1.Remove the drain plug and gasket, to drain the fluid.
2.Install the drain plug and new gasket, and tighten to the specified torque.
Tightening torque: 35 ± 4 N·m
3.Remove the filler plug and gasket, and fill the fluid up to the lower edge of the filler plug hole.
Brand name:
MITSUBISHI MOTORS GENUINE ATF SP III
Quantity: Approximately 3.1 L
note
  1. If the valve body assembly is replaced, refill the fluid and then install the filler plug with the gasket.

    Quantity: Approximately 3.1 L
  • Drive the vehicle at 40 km/h for at least five minutes, and then refill the fluid up to the lower edge of the filler plug hole.

    • Quantity: Addition of approximately 0.4 L
    4.Install the filler plug and new gasket, and tighten to the specified torque.
    Tightening torque: 32 ± 2 N·m