REMOVAL AND INSTALLATION



caution
  • Do not apply lubricant (grease or silicon system sprayer etc.) to the switch and the switch installation section to avoid malfunction of the switch. In addition, do not use gloves which have lubricant (grease or silicon system sprayer etc.) on them.
  • When the brake pedal assembly is replaced/adjusted or the brake pedal stroke sensor is replaced, execute the special function (PHEV-ECU) "Item No. 2: Brake pedal stroke sensor learning reset" or disconnect the auxiliary battery terminals and then leave it disconnected for at least ten seconds.<PHEV>
  • Keep away the brake pedal stroke sensor from a magnetic device.<PHEV>
Pre-removal operation
  • Front Scuff Plate <LH> and Cowl Side Trim <LH> Removal (Refer to GROUP 52A, Interior Trim .)
  • Steering Column Lower Cover and Side Lower Panel Removal (Refer to GROUP 52A, Instrument Panel Assembly .)

Post-installation operation
  • Steering Column Lower Cover and Side Lower Panel Installation (Refer to GROUP 52A, Instrument Panel Assembly .)
  • Front Scuff Plate <LH> and Cowl Side Trim <LH> Installation (Refer to GROUP 52A, Interior Trim .)





Brake pedal assembly removal steps


1.
Stop lamp switch connector connection


2.
Stop lamp switch


3.
Pedal clip


4.
Pedal stopper


5.
Snap pin


6.
Pin assembly


7.
Pedal pad
<<A>>

8.
Brake pedal assembly



Brake pedal stroke sensor removal steps <PHEV>


·
Brake pedal stroke sensor connector connection


9.
Brake pedal stroke sensor assembly

REMOVAL SERVICE POINT



<<A>> BRAKE PEDAL ASSEMBLY REMOVAL


From the engine compartment side, remove the brake pedal assembly while pulling the brake booster.