REMOVAL AND INSTALLATION


Pre-removal operationFront Splash Shield Removal (Refer to GROUP 42A - Splash Shield ).
Post-installation operationFront Splash Shield Installation (Refer to GROUP 42A - Splash Shield ).




Removal steps


·
Vacuum pipe assembly A connection (Refer to <LHD>, <RHD>)
<<A>>
>> A<<
1.
Vacuum hose E and Vacuum tank
<<A>>
>> A <<
2.
Hose clip
<<A>>
>> A<<
3.
Vacuum hose E connection
<<A>>
>> A <<
4.
Vacuum tank

REMOVAL SERVICE POINT



<<A>> HOSE CLIP, VACCUM HOSE E AND VACCUM TANK REMOVAL


1.Disconnect vacuum hose E from vacuum pipe assembly A (Refer to <LHD>, <RHD>).

2.Hook vacuum hose C in the support on the top of the vacuum tank.
3.Remove the vacuum tank with vacuum hose C hooked in the support.
4.Cut the hose clip to disconnect vacuum hose C.

INSTALLATION SERVICE POINTS



>>A<< HOSE CLIP, VACCUM HOSE E AND VACCUM TANK INSTALLATION



1.Align the mark on the vacuum hose with the projection on the vacuum pump fitting. Then insert the hose securely and secure it with the hose clip.
2.Install the vacuum tank with vacuum hose C attached, and then tighten the nuts and bolts to the specified torque.
Tightening torque: 14 ± 3 N·m
3.Connect vacuum hose C and the vacuum pipe assembly (Refer to <LHD>, <RHD>).