REMOVAL AND INSTALLATION <FRONT>



danger
  • When servicing the high-voltage system parts, be sure to wear the specified protection equipment and disconnect the service plug to interrupt the high-voltage supply (Refer to ).
  • Do not disassemble any on board charger/DC-DC converter other than those described in this manual.
Pre-removal Operation
  • Under cover removal (Refer to GROUP 51 - Under Cover )
  • Battery front protector <LH> removal ()
  • PDU cover removal ()

Post-installation Operation
  • PDU cover installation ()
  • Battery front protector <LH> installation ()
  • Under cover installation (Refer to GROUP 51 - Under Cover )





Removal steps


1.
Cable protector
<<A>>
>>A<<
2.
Drive battery front cable (P, N line)

REMOVAL SERVICE POINTS



<<A>> DRIVE BATTERY FRONT CABLE (P, N LINE) REMOVAL (DRIVE BATTERY ASSEMBLY SIDE)



1.Remove the inner cable mounting bolts (2 locations).
2.Remove the outer cable mounting bolts (2 locations).
3.Pull out the drive battery front cable (P, N line) from the drive battery assembly.

INSTALLATION SERVICE POINTS



>>A<< DRIVE BATTERY FRONT CABLE (P, N LINE) INSTALLATION (DRIVE BATTERY ASSEMBLY SIDE)


caution Engage the cable as shown, keeping it straight.


1.Drive battery front cable (P, N line) is installed in drive battery.
2.Install the outer cable mounting bolts and inner cable mounting bolts in this order and tighten them to the specified torque.
Tightening torque: 7.0 ± 2.0 N·m