REMOVAL AND INSTALLATION







Power transistor removal steps


·
Bottom cover assembly (passenger’s side) (Refer to GROUP 52A - Instrument Panel ).


1.
Power transistor



Blower motor removal steps


·
Bottom cover assembly (passenger’s side) (Refer to GROUP 52A - Instrument Panel ).


2.
Hose


3.
Blower motor





Air mixing damper control motor, mode selection damper control motor removal steps


·
Foot duct (Refer to ).
<<A>>

4.
Air mixing damper control motor <Vehicles with Single-zone AUTO A/C> or Air mixing damper control motor (RH) <Vehicles with Dual-zone AUTO A/C>
<<A>>

5.
Air mixing damper control motor (LH) <Vehicles with Dual-zone AUTO A/C>
<<A>>

6.
Mode selection damper control motor





Outside/inside air selection damper control motor removal steps


·
Glove box, Globe box assembly (Refer to GROUP 52A - Instrument Panel ).


7.
Clean air filter cover

>>B<<
8.
Clean air filter
<<A>>
>>A<<
9.
Outside/inside air selection damper control motor

REMOVAL SERVICE POINT



<<A>> AIR MIXING DAMPER CONTROL MOTOR, OUTSIDE/INSIDE AIR SELECTION DAMPER CONTROL MOTOR, MODE SELECTION DAMPER CONTROL MOTOR REMOVAL



note A normal plate-type ratchet driver is recommended.

INSTALLATION SERVICE POINT



>>A<< OUTSIDE/INSIDE AIR SELECTION DAMPER CONTROL MOTOR INSTALLATION


Install the outside/inside air selection damper control motor while pressing the outside/inside air selection damper from the hole of the blower motor.

>>B<< CLEAN AIR FILTER INSTALLATION



Install the clean air filter in the direction shown.