|
1.Use special tool flywheel stopper (MD998781) to secure the A/T drive plate. 2.Remove the A/T drive plate bolts.
|
|
1.Apply a small amount of engine oil to the entire inner diameter of the crankshaft rear oil seal lip. 2.Use special tool crankshaft rear oil seal installer (MD998718) to press-fit the crankshaft rear oil seal.
|
|
Install the crankshaft A/T drive plate adapter and A/T drive plate adapter plate on the A/T drive plate in the direction shown in the illustration.
|
|
1.Use special tool flywheel stopper (MD998781) to secure the A/T drive plate in the same manner as removal. 2.Tighten the A/T drive plate bolts to the specified torque. Tightening torque: 74 ± 2 N·m
|
|
1.Apply a small amount of engine oil to the entire inner diameter of the crankshaft front oil seal lip. 2.Apply a small amount of engine oil to the outer diameter of special tool crankshaft front oil seal installer (guide) (MD998717) and install it to the crankshaft. 3.Use special tool crankshaft front oil seal installer (MD998717) to press-fit the crankshaft front oil seal.
|
|
To prevent the crankshaft pulley mounting bolt from being loosened, wipe off the dirt on the crankshaft sprocket and the crankshaft as shown in the figure. Also, wipe off the dirt on the crankshaft spacer, crankshaft sensing blade, crankshaft sprocket, and crankshaft as shown in the figure. Then degrease the areas, and install them.
|