ENGINE OIL FILTER REPLACEMENT <4M4>


1.Start the engine and allow it to warm up until the temperature of the coolant reaches 80 °C to 90 °C.
2.
warning Use care as oil could be hot.
Remove the engine oil filler cap.
3.Remove the drain plug to drain oil.
4.Remove the under cover.

5.Use special tool oil filter wrench (MH061590) to remove the engine oil filter.
6.Clean the filter bracket side mounting surface.

7.Apply a small amount of engine oil to the O-ring of the new oil filter.
8.Once the O-ring of the oil filter is touching the flange, use the special tool to tighten to the specified torque.
Tightening torque: Approximately 3/4 turn (22 ± 2 N·m)
9.Install the drain plug and refill the engine oil (Refer to ).
10.Race the engine 2-3 times, and check to be sure that no engine oil leaks from installation section of the oil filter.