

|
1.Before inspection, set the vehicle to the pre-inspection condition. 2.Turn the ignition switch to "LOCK" (OFF) position. 3.Connect the M.U.T.-III to the diagnosis connector.
|

|
4.Set the timing light to the power supply line (terminal No. 3) of the ignition coil No.
1.
| note |
The power supply line is looped and also longer than the other ones.
|
5.Start the engine and let it run at idle. 6.Check that ignition timing is at the standard value. Standard value: approximately 10° BTDC
| note |
- The ignition timing may fluctuate within ±7°. This is normal.
- In higher altitude, the ignition timing is more advanced than the standard value
by approximately 5°.
- Wait till approximately 1 minute passes after the engine started, and check the
ignition timing when the engine stabilized.
|
7.Run the engine at 2,000 - 3,000 r/min for 2 minutes. 8.Set the CO, HC tester. 9.Check the CO contents and the HC contents at idle. Standard value
CO contents: 0.1 % or less HC contents: 100 ppm or less
10.If there is a deviation from the standard value, inspect the MPI system (Refer to
GROUP 13D - Troubleshooting - Inspection Chart for Trouble Symptoms ) 11.Remove the timing light and CO, HC tester. 12.Turn the ignition switch to "LOCK" (OFF) position and then disconnect the M.U.T.-III.
|