REMOVAL AND INSTALLATION



Pre-removal and Post-installation Operation
  • Timing Chain Case Removal and Installation (Refer to ).





Removal steps


·
Inlet camshaft assembly (Refer to )
<<A>>
>>B<<
1.
Timing chain tensioner


2.
Timing chain tension side guide


3.
Timing chain loose side guide

>>A<<
4.
Valve timing chain and crankshaft sprocket


5.
Valve timing chain

>>A<<
6.
Crankshaft sprocket

>>A<<
7.
Crankshaft spacer

REMOVAL SERVICE POINT



<<A>> TIMING CHAIN TENSIONER REMOVAL


1.Temporarily install the crankshaft pulley to the crankshaft.


2.
caution Never turn the crankshaft anti-clockwise.
Turn the crankshaft clockwise to align the sprocket timing marks as shown in the figure and set the No. 1 cylinder to the top dead centre of compression.
note At this time, it is not necessary that the link plates (blue) of the valve timing chain always aligns with each sprocket timing mark.
3.Remove the crankshaft pulley installed temporarily.

4.
warning If the timing chain tensioner set pin (fixed wire) suddenly comes off the timing chain tensioner, it is very dangerous because the plunger jumps out.
Compress the plunger of timing chain tensioner and insert hard wire (such as the piano wire) or the L-shaped hexagon wrench (1.0 mm) to fix the plunger of the timing chain tensioner.
5.Remove the timing chain tensioner.

INSTALLATION SERVICE POINTS



>>A<< CRANKSHAFT SPACER/CRANKSHAFT SPROCKET/VALVE TIMING CHAIN AND CRANKSHAFT SPROCKET INSTALLATION



1.After wiping off the dirt on the crankshaft sprocket and crankshaft spacer as shown in the figure using a rag, degrease the areas.
note Degrease them to prevent drop in the friction coefficient of the pressed area, which is caused by oil adhesion.


2.Set the timing marks of the camshaft sprocket and the crankshaft sprocket as shown in the figure.

3.Set the tool onto the hexagon part of the camshaft, and turn it clockwise to avoid slack of the chain tension side.

4.Align the timing chain mating mark on each sprocket with the link plates (blue) of valve timing chain, and install the valve timing chain to each sprocket.

>>B<< TIMING CHAIN TENSIONER INSTALLATION



1.Check that the sprocket timing chain mating marks align with the link plates (blue) of the valve timing chain, and install the timing chain tensioner to the cylinder block.

2.
warning If the timing chain tensioner set pin (fixed wire) suddenly comes off the timing chain tensioner, it is very dangerous because the plunger jumps out.
Remove the hard wire or L-shaped hexagon wrench fixing the plunger of the timing chain tensioner to apply tension to the valve timing chain.