Code No. P0513: Immobilizer Malfunction


FUNCTION



  • The engine-ECU transmits to and receives from KOS-ECU <Vehicles with KOS> or WCM <Vehicles with WCM> a control signal to authenticate the ignition key.
    note
    • This code may be displayed due to radio interference if there are multiple registered ignition keys nearby during engine start.
    • This code may be displayed when the transponder ID code is registered.
    • This code is also displayed when the ignition key code is not recognized.
    • When this code is displayed, it is also sent to KOS-ECU <Vehicles with KOS> or WCM <Vehicles with WCM>

TROUBLE JUDGMENT


Check Condition
  • Ignition switch is in "ON" position.
Judgment Criterion
  • The check result of the KOS-ECU <Vehicles with KOS> or WCM <Vehicles with WCM> is not suitable for that of the engine-ECU.

FAIL-SAFE AND BACKUP FUNCTION



  • None

PROBABLE CAUSES



  • Failed KOS-ECU <Vehicles with KOS> or WCM <Vehicles with WCM>
  • Failed engine-ECU

DIAGNOSIS PROCEDURE

STEP 1. M.U.T.-III other system diagnosis code.

  • Confirm whether the diagnosis codes are set from KOS-ECU <Vehicles with KOS> or WCM <Vehicles with WCM>.

Q. Is the diagnosis code set?

Perform the troubleshooting of KOS-system <Vehicles with KOS> or WCM-system <Vehicles with WCM> (Refer to GROUP 42B - Troubleshooting - Diagnosis Code Chart <Vehicles with KOS>, Refer to GROUP 42C - Troubleshooting - Diagnosis Code Chart <Vehicles with WCM>).
Go to Step 2 .

STEP 2. M.U.T.-III diagnosis code

  • Reconfirmation of diagnosis code.

Q. Is the diagnosis code set?
Replace the KOS-ECU <Vehicles with KOS> or WCM <Vehicles with WCM>. After the replacement, put the each identification code into KOS-ECU <Vehicles with KOS> or WCM <Vehicles with WCM> [Refer to GROUP 42B - On-vehicle Service - ID Codes Registration Procedures <Vehicles with KOS>, Refer to GROUP 42C - On-vehicle Service - ID Codes Registration Procedure (For Extra or New Key) <Vehicles with WCM>]. Then go to Step 3 .
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent malfunctions ).

STEP 3. M.U.T.-III diagnosis code



  • Reconfirmation of diagnosis code.

Q. Is the diagnosis code set?
Replace the engine-ECU.
Check end.